Gear maker Posted February 1, 2017 Share Posted February 1, 2017 First time I've noticed this happening. In the attached file I have an arc with a pressure profile. On one end of the arc (upper right) the pressure profile is ignoring the cap. If I use a Butt Cap then this is not very noticeable, actually there is a slight line. But with either a Round or Square Cap this is a problem. I drew this arc using the pen tool and modifying the curve with the node tool. I saved the file, exited and reentered AD the problem still was visible. I tried repeating the problem in a new drawing and it didn't occur. No idea what triggered it in the first place. I'm hoping you can figure out the cause. Test4.afdesign iMac (27-inch, Late 2009) with macOS Sierra Link to comment Share on other sites More sharing options...
Chris_K Posted February 2, 2017 Share Posted February 2, 2017 Hi Gear Maker Thanks for reporting this. This is something that was raised previously so we do have it logged. Hopefully it will be sorted soon Cheers Serif Europe Ltd - Check the latest news at www.affinity.serif.com Link to comment Share on other sites More sharing options...
Gear maker Posted February 2, 2017 Author Share Posted February 2, 2017 Hi Chris, I hope my file helps as I was not able to repeat the problem. Thanks for looking into it. Mike iMac (27-inch, Late 2009) with macOS Sierra Link to comment Share on other sites More sharing options...
Recommended Posts